[Chimera-users] question on visualization

[Gabor PAPAI]

Hi Jianhao,

You have to untick the “cap high values at box faces” to see surfaces bellow 0 threshold. You can find this option in Volume Viewer -> Features -> Surface and Mesh options at the bottom of the panel.

Best regards,
Gabor
---
Gabor Papai
IGBMC
Integrated Structural Biology
1, rue Laurent Fries, Bp 10142
67404 Illkirch, France
Tel: +33-3-69485288

On 1 Dec 2017, at 4:43 , C.J. <biocjh at gmail.com<mailto:biocjh at gmail.com>> wrote:

Hi specialists,

I have a problem when adjusting the level of a map. If the level > 0, it seemed OK, but when it is less than 0, it showed a solid box. This is different from EMAN2. In EMAN2, the threshold less than 0 also works. I'm not sure whether the defining of level is the same as the threshold in EMAN2. Or is there any other way to show the density of a map as in EMAN2 with threshold less than 0?
Some snapshots of the visualization in both programs are attached to the post.
Thank you!


regards,
Jianhao
<7a.png><7b.png><10a.png><10b.png>_______________________________________________
Chimera-users mailing list: Chimera-users at cgl.ucsf.edu<mailto:Chimera-users at cgl.ucsf.edu>
Manage subscription: http://plato.cgl.ucsf.edu/mailman/listinfo/chimera-users

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://plato.cgl.ucsf.edu/pipermail/chimera-users/attachments/20171201/d65a3ca3/attachment.html>